Enterasys SSR-GLX70-01 Bedienungsanleitung PDF herunterladen (Seite 29)

INFORMATIONAL NOTES AND STATEMENTS

10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 29 of 34

F0615-F Subject to Change Without Notice

PCMCIA Card File System Manual

4. Temporarily boot a System Firmware image over the network through the following command:

XP-boot> boot <directory> <image-file-name>

5. After the System Firmware finishes booting, copy the System Firmware image from the TFTP

server to the PCMCIA card as follows:

xp# system image add <IPaddr-of-TFTP-host> <directory> <image-file-name>

6. Configure the Boot Firmware to boot the System Firmware image added to the PCMCIA card by

entering the following command:

xp# system image choose <image-file-name>

7. Optionally, the user may reboot the system to verify the above process.

SmartTRUNK Manual

When Spanning Tree Protocol (STP) is enabled on a SmartTRUNK, one link in the SmartTRUNK

participates in STP. If you use STP with a SmartTRUNK that consists of ports of the same type,

Enterasys Networks recommends that the ports in the SmartTRUNK be neighbors (i.e., in

consecutive order) on the same line card.

When SmartTRUNKing to an Ethernet GigaSwitch product, the IFG of the X-Pedition must be set to

4 or greater to allow the GigaSwitch time to properly process incoming frames.

If a SmartTRUNK has been configured to carry traffic for an IP VLAN and you want to have it carry

traffic for the L2 default VLAN as well, you must make the SmartTRUNK into an 802.1Q trunk, then

disable and enable the SmartTRUNK.

When hot swapping is performed on any card, the link for any SmartTRUNK configured with

Huntgroup protocol goes down for a few seconds.

If you hot-swap a card that has SmartTRUNK configured along with Layer 2 filters, the

SmartTRUNK commands are marked with an “E”.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Keine Kommentare

Enterasys SSR-GLX70-01 Bedienungsanleitung Seite 29