ISSUES RESOLVED IN E8.2.1.1
10/24/01 P/N: 9038090-17 CUSTOMER RELEASE NOTES Page: 19 of 34
F0615-F Subject to Change Without Notice
Telnet I.D.
Telnet users do not see error messages generated during a Telnet session.
Example (Normal Operation) :
xp(config)# vlan add ports gi.3.3 to red
%CLI-W-MODNOTFOUND, gi.3.3: module '3' does not exist - ignoring
%CLI-E-IVPORTLIST, invalid port list 'gi.3.3'
In this case, the error messages above will not be returned to the Telnet user. Serial console
sessions do not have this problem. This issue was resolved in E8.1.0.8.
01501
With this release, "inactive" Telnet sessions (during which a connection was opened but the “Enter"
key was never pressed to activate the session) will timeout, allowing the connection of other Telnet
sessions to the X-Pedition. The timeout value may be set with the Configure-mode command
system set idle-timeout telnet x, where ‘x’ represents time in minutes. This issue was resolved in
E8.2.0.5.
01557
Trivial File Transfer Protocol (TFTP) I.D.
When using TFTP to copy configurations from the X-Pedition to external TFTP servers, the marks
around comments in the configuration will not be transferred. Consequently, any previously
commented line in the configuration is no longer considered commented when the external TFTP
server receives the file. This issue was resolved in E8.1.0.9.
F1367
Virtual Local Area Network (VLAN) I.D.
Applying the qos set and port flow-bridging configuration commands to a VLAN will cause traffic
to be flooded through all ports in the VLAN.
F1799
Virtual Router Redundancy Protocol (VRRP) I.D.
Extremely high levels of CPU utilization may delay VRRP packets. This issue was resolved in
E8.1.0.8.
F1433
With this release, VRRP can no longer be configured on a loopback interface. F1488
When an exit port is disconnected, flows will not be removed if traffic directed toward the
disconnected port does not decrease. This results in improper failover to other/backup routes. This
issue was introduced in E8.0.1.2.
F1582
F1588
Attempting to enter the ip-redundancy show vrrp interface x command, when ‘x’ is any string that
is not a VRRP interface, may cause the X-Pedition to core dump or print out an error message. This
issue was resolved in E8.2.0.12.
01686
(5 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern