Enterasys ANG-1100 Betriebsanweisung PDF herunterladen (Seite 18)

6 Aurorean Network Gateway-1100 User’s Guide

Connecting Cables Chapter 2

Installation

Connecting an ANG-1102/1105

The ANG-1100 is typically set up in the configuration shown below.

Figure 6 Connecting the ANG-1100

To connect the ANG-1100 Ethernet port, perform the following steps:

1 Do one of the following as shown in Figure 7:

– If you are connecting an ANG-1102 to a hub, plug one end of a

straight-through Ethernet cable into the ANG’s trusted port. If

you are connecting an ANG-1105 to a PC, plug one end of a

straight-through cable into the ANG’s trusted port. If you are

connecting an ANG-1105 to a hub, plug one end of the red, cross-

over cable to a trusted port. Go to Step 2.

– If you are connecting the ANG-1102 directly to a computer, attach

one end of the red, cross-over cable to a trusted port and the other

end to an RJ45 connector on your computer. Skip to Step 3.

2 Plug the opposite end of the cable into a wall jack, patch panel, or hub

linked to a protected network segment.

Aurorean Network

Trusted (LAN)

connection

External (WAN)

connection

Hub

INTERNET

Site-to-site tunnel

ANG-3000/7000

User

Users

Cable / DSL

Modem

Gateway-1100

Site-to-site tunnel

Internet connection

Trusted connection

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 77 78

Keine Kommentare

Enterasys ANG-1100 Betriebsanweisung Seite 18