Enterasys Matrix 7H4385-49 Installationsanleitung PDF herunterladen (Seite 51)

Commission the MSM to Run Trusted Access Gateway

Enterasys Matrix Security Module Installation Guide 4-3

11. Ifyouwillbeaccessinganameserver,highlightYesandpressEnter.

TheSELECTNAMESERVERscreenappears.

12. EntertheprimarynameserverIPaddress,highlightOKandpressEnter.

TheCONFIRMNETWORKSETUPscreenappears.

13. Verifyyourinformation,highlightACCEPT,andpressEnter.PressEnteragaininthe

second

verificationscreentoaccept.

Basicnetworkconfigurationiscomplete.TheENTERMANAGEMENTSERVERIP

screenappears.

14. EntertheIPaddressofthemanagementserver,highlightOKandpressEnter.

TheHWCLOCKscreenappears.

15. Selectthehardwareclocksetting,andthenthetimezoneconfiguration.HighlightOK,

andpressEnter.

TheENABLE

SNMPDAEMONscreenappears.

16. TomonitortheMSMviaanSNMPnodemanager,highlightYESandpressEnter.

TheENTERSYSTEMCONTACTand thentheENTERSYSTEMLOCATIONscreens

appear.

17. Enterthesystemcontactandthesystemlocation.HighlightOKandpressEnter.

TheREADCOMMUNITYSTRING,WRITE COMMUNITYSTRING,ACCESS

CONTROL,

SNMPTRAPDESTINATION,andtheTRAPCOMMUNITYscreens

appear.

18. Enterthereadcommunitystring,writecommunitystring,AccessControl (IPaddress

fromwhichtoacceptcommunitynames),SNMPtrapdestination,andthetrap

communitystring.

19. HighlightOKandpressEnter.

20. Commissioningiscomplete.Rebootthesystem.

21. Duringthecommissioningprocess,the

MSMIPaddressisautomaticallyconfigured

onthefrontpanelEthernetport(eth0).ToconfiguretheIPaddressonabackpanel

Ethernetport(eth1oreth2),youmusteditthe/etc/rc.d/rc.inet1.conffileandenterthe

IPaddressandnetmaskintheappropriateplacefortheinterface(s)youwantto

configure.

ItisrecommendedthatyoudonotuseDHCP.Inaddition,atthebottomof

thefileyoucanchangethedefaultgatewayIPaddressyouspecifiedduringthe

commissioningprocess,ifdesired.

Note: To change the IP address of the management server, type the following command

at the MSM CLI: /opt/tag/configMgmtIP

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 65 66

Keine Kommentare

Enterasys Matrix 7H4385-49 Installationsanleitung Seite 51