Enterasys SecureStack A2 A2H124-48P Installationsanleitung PDF herunterladen (Seite 43)

Connecting AC and PoE Power

SecureStack A2 PoE Installation Guide 3-13

3. ObservethepowerCPULED(notshown),locatedonthefrontpanel.Duringthe

initialization,theCPULEDwillstartbyilluminatingsolidamber,thenstartblinking

green,thenblinkingamber,thenblinkinggreenagainuntiltheendofthe

initialization,andthenturnssolidgreen.

Iftheswitchisa

standaloneswitch,itwilltakeapproximately30 secondsforthe

switchtostartup.IftheswitchisastackManager,itcantakeupto3minutesormore

tostartup,dependingonthenumberofMemberswitchesinthestack.

C2RPS-PoE Redundant Power System

Ifyouareinstallinganoptionalredundantpowersystem(C2RPS‐POE),refertothe

installationinstructionssuppliedwiththeSecureStackC2RPS‐POE.Theswitchis

connectedtoaC2RPS‐POEusingaC2RPS‐POECable.

Figure 3-7 Accessing the RPS connector

Note: If the CPU LED illuminates solid red, there was a critical failure. For more

information about the LED indications and troubleshooting, refer to Chapter 4. If you need

additional help, contact Enterasys Networks. Refer to “Getting Help” on page 1-7 for

details.

1 RPS coverplate 3 Screw holes for coverplate

2 Retaining screws to fasten plate

Redundant Power Supply

DC Line 12V /13A MAX.

MAC ADDRESS SERIAL NO.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 81 82

Keine Kommentare

Enterasys SecureStack A2 A2H124-48P Installationsanleitung Seite 43