Enterasys SecureStack A2 A2H123-24 Installationsanleitung PDF herunterladen (Seite 29)

Installing the Switch on a Flat Surface

SecureStack A2 Installation Guide 3-3

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubberfeetis

recommendedtopreventtheswitchfromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to“Installingthe

RubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage 3‐6.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 3‐1andproceedasfollows:

1. Placetheswitchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethefourrubberfeetfromtheirplasticbagintheshippingbox.

3. Locatethefourmarkedlocationson

thebottomfourcornersofthechassis.

4. Removetheprotectivestripfromthebackofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeetintheotherthreelocations.

5. Afterinstallingtherubberfeet,return

theswitchtoitsuprightposition.

6. Proceedto“GuidelinesforFlatSurfaceInstallation”onpage 3‐5.Forarackmount

installation,proceedto“RackMountingtheSwitch”onpage 3‐6.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Keine Kommentare

Enterasys SecureStack A2 A2H123-24 Installationsanleitung Seite 29