Enterasys C2RPS-SYS Installationsanleitung PDF herunterladen (Seite 37)

Rack Mounting the Switch

SecureStack A2 Installation Guide 3-9

Ifyouareinstallingseveralswitchesinastack,proceedto“ConnectingStackingCables”

onpage3‐11.Iftheswitchisbeinginstalledasastandaloneswitch,proceedto

“ConnectingACandRPS‐SYSPower”onpage3‐15forpowerconnectioninstructions.

Figure 3-5 Area Guidelines for Switch Installation on Flat Surface

Rack Mounting the Switch

Toinstalltheswitchina19‐inchrack,youneed:

•Tworackmountbracketsandmountingscrews(rackmountkit)shippedwiththe

switch.

•Fouruser‐suppliedscrewstoattachtheswitchtoastandard19‐inchrack.

Caution: To ensure proper ventilation and prevent overheating, leave a minimum

clearance space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.

Do not connect the switch to the AC power source until instructed to do so later in the

installation process.

Precaución: Para asegurar una buena ventilación y evitar que el sistema se

sobrecaliente, deje un espacio mínimo de 5.1 cm (2 pulgadas) con respecto a los lados y

a la parte posterior del aparato.

No conecte el dipositivo a la fuente primaria hasta que no se le indique.

1 Approximately 152 cm (5 ft) from power source 3 44.5 cm (19.4 in.) for proper ventilation

2 4.45 cm (1.75 in.) per switch. (Vertical clearance

depends on number of switches stacked.)

4 41.9 cm (16.5 in.) for proper ventilation

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Keine Kommentare

Enterasys C2RPS-SYS Installationsanleitung Seite 37