Enterasys APS-3000 Bedienungsanleitung PDF herunterladen (Seite 4)

Release Notes

3.9 Days Remaining not displayed on Home->License page when permanent license is installed (Case 9767)

Home->License page does not display the Days Remaining field when a permanent license is installed

on a customer AMP.

3.10 Modify These Devices works for a large number of APs

Now, AMP is able to change the credentials on a large number of devices using the “Modify These

Devices”.

3.11 AMP handles bad data from APs

Now the AMP daemon does not die when bad data is fetched from the Cisco devices: IOS and vxworks.

3.12 Pg_autovacuum is rotated (Case 9725)

AMP now rotates pg_autovaccum log files.

3.13 AMP handles “#” in banner commands

Now the AMP is able to parse “#” in banner section in the running config on a Cisco IOS AP.

3.14 AMP now supports Cisco 1200 APs with 802.11a radio only

AMP correctly displays the radio information on a Cisco 1200 IOS AP which has only the 802.11a

radio. Previously the AMP did not display the channel and other information correctly.

3.15 System->Scheduling page errors fixed (Case 9616)

Users who have scheduled events related to rogue scanning on Intel/Symbol APs no longer have errors

on the System->Scheduling page. Please contact AirWave support if you encounter this problem.

3.16 AMP accepts licenses after doing a data restore on the AMP

Previously users who did only a data restore could not enter a new license key. Now the AMP accepts a

new license key on an AMP which had only the data restored.

3.17 Static IP assignment feature works on LANCOM and Cisco IOS APs (Case 9048)

The Static IP assignment feature which is enabled on the Group->Basic page works now with the

LANCOM APs and the Cisco IOS APs using Advanced Group Configuration.

3.18 Lancom APs report IP address correctly

Now the AMP reads and displays the IP information on the LANCOM APs correctly.

3.19 AMP no longer reports bandwidth for down APs

Previously the AMP reported bandwidth for down APs which had some bandwidth sometime in the past.

Now the bandwidth is reported at 0 when the AP is down.

3.20 “Modify These Devices” from Group->Monitor page works as expected (Case 9588)

The AMP displays only the APs in the group when “Modify These Devices” is selected from the Group-

>Monitor page.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Enterasys APS-3000 Bedienungsanleitung Seite 4