Enterasys ANG-3000 Spezifikationen PDF herunterladen (Seite 87)

Bootrom Monitor Mode Commands

XSR Getting Started Guide 3-41

remove

This command removes a file using the syntax remove <source name> <destination name>

rename

This command renames a file using the syntax rename <source name> <destination name>

This command displays boot values. Sample output is shown as follows:

XSR-1800: sb

Current boot file is xsr1800.fls

Boot selector default is flashrom, compactFlash, network

Available Network boot devices: Eth1

This command shows a fault report. Sample output is shown as follows:

XSR-1800: sf

No fault report at 0x1feef00

This command displays system inventory. Sample output is shown as follows:

XSR-1800: si

IBM PowerPC 405GP Rev. D

Processor speed = 200 MHz

PLB speed = 100 MHz

OPB speed = 33 MHz

Ext Bus speed = 25 MHz

PCI Bus speed = 33 MHz (Sync)

Internal PCI arbiter enabled

RAM installed: 32MB

Flash installed: 8MB on processor board

CompactFlash: SunDisk SDP 5/3 0.6 has 32047104 bytes

Real Time Clock

FastEthernet 1

FastEthernet 2 Rev 0

H/W Encryption Accelerator Rev 1

T1E1 has 4 channelized ports on NIM slot 1. Rev 0

ISDN BRI has 2 ST ports in NIM slot 2. Rev 1

Empty internal NIM slot 3

System up for 345 seconds.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 113 114

Keine Kommentare

Enterasys ANG-3000 Spezifikationen Seite 87